Table of Contents
Advertisement
ASSEMBLY
Fig 59
8. Locate the fence mitre casting and lift and shift hand (24).
Insert the locking handle with washer through the elongated
slot in the fence mitre casting and down into the threaded hole
in the scale casting. This is mounted to the side of the sliding
table (28), see fig 60-61.
Fig 60-61
Scale casting
Mitre casting
28
24
9. Remove the washer/nut from the tool post (25), insert the
post down through the machined holes in both mitre casting
(24) and sliding table (28) and secure using the washer/nut,
see fig 62.
10. Loosen the hold down clamping knob (26) and slide the
assembly down the tool post (25) and clamp in position, see
fig 63.
11. Loosen the butterfly knobs on the mitre casting (24), insert
the 'T' bolts into the fence's 'T' slot rail (29). Lift-up the 90˚ stop
located in the corners of the sliding table (28) and push the
fence up against the stop, see fig 64-65.
Butterfly knobs
16
Fig 62
25
Fig 63
Fig 64-65-66-67
29
'T' Bolt
26
Advertisement
Table of Contents
