Table of Contents
Advertisement
ASSEMBLY
Fig 16-17
Clamping knob
Insert plate
7. Raise the saw by first releasing the rise & fall operating
wheel clamping knob, remove the five cross head screws
holding the table insert and place safely aside, see 16-17.
Raise the saw to its maximum height by turning the
operating wheel anti-clockwise.
8. Find the riving knife (H) loosen the two nuts holding the
riving knife clamping plates, slide the riving knife down
between the two plates and lightly tighten to hold the riving
knife in place. Check that the tip of the knife has a clearance
of 3-8mm between the blade. Adjust the four grub screws to
the opposite side of the clamping plate to aline the riving
knife with the blade. Tighten the nuts to secure the riving
knife in place, see fig18-19-20. Adjust the levelling grub
screws on the insert plate so it's level with the main table,
see fig 21. Re-secure the insert plate.
Fig 18-19-20-21
H
H
Clamping plates
H
3-8mm Gap between the
riving knife and the blade
Grub screws
9. Locate the crown guard (K), flexible hose (L) and hose
clips (M). Loosen the lift & shift handle on the crown guard.
Introduce the slot to the rear of the crown guard (K) over the
riving knife and slot pin bolt into the curved slot in the riving
knife. Tighten the handle, see fig 22.
K
Curved slot
NOTE: DO NOT OVERTIGHTEN AS THE CROWN
GUARD IS PLASTIC AND COULD BE DAMAGED!
10. Locate the flexible hose (L), place a hose clip (M) over one
end. Insert the hose over the extraction outlet on the crown
guard (K) and tighten the clip. Place the remaining clip over
the opposite end of the hose, insert the hose over the
extraction out moulding (J) and tighten, see fig 23-24.
J
10
L
Levelling
grub screws
Fig 22
Fig 23-34
M
Advertisement
Table of Contents
