Axminster WORKSHOP AW216TS Original Instructions Manual page 12

ASSEMBLY
107712-107713 Basic Saw
AW216TS Table Saw assembled for work bench set up
104931 Optional Floor Stand for AW216TS
106804 Optional Floor Stand for AW254TS
Locate all the components on page 04 and assemble as follows.
Step 1
3
Step 2
Step 3
7
5
3
2
4
Mounting the Stand to the Saw
Remove the rip fence, crown guard and hose and lower saw
blade below the table. With assistance turn the saw assembly
(A) over & remove the four rubber feet (T). Place the base plate
(W) on top and align the holes as shown in step 5. Lower the
stand on top of the saw, line up the holes and secure using the
caphead bolts & washers (19). Place the assembly upright on
the floor, see step 6.
1
19
12
6
W
Line up the holes
A
Step 4
Step 5
Step 6