Coms-Clear Cmos Data; Sw1-Power On Mode At Or Atx Selection - JHCTech PADR-M101 User Manual

2.2.2 COMS-Clear CMOS data

The motherboard coastline
BIOS information. Normally this switch should be set with pins 1-2 closed. If you want to reset the CMOS
data, set SW2 to 2-3 closed for just a few seconds, and then move the jumper back to 1-2 closed. This
procedure will reset the CMOS to its default setting.

2.2.3 SW1-Power on mode AT or ATX selection

The motherboard coastline
Figure 2.4
of PADR-M101 contains a switch that can erase CMOS data and reset the system
Figure 2.5
of PADR-M101 provides a AT/ATX Switch, which users can set Power-on
12
User's Manual