Install The Memory Module - JHCTech PADR-M101 User Manual

User's Manual
Step 4: Follow the disassembly and assembly steps and use the opposite steps to complete the hard disk
cover installation.

2.4.3 Install the memory module

Step 1: Same as steps one and two in 2.4.1, unscrew and remove the SARA hard disk cable and then
remove the hard disk cover assembly;
Step 2: If there is an OFX-075 module, remove the wide voltage module;
Step 3: Remove the SATA cable as shown in the figure;
Figure 2.10
Step 4: Unscrew a total of 6 screws on the front and rear panels as shown in the figure, then remove the
fan cover and turn the machine upside down.
Figure 2.11
32