Power Input Connector (Cn1); Ethernet Port (Lan1/Lan2) - JHCTech PADR-M101 User Manual

2.3.1 Power Input Connector (CN1)

PADR-M101 uses a power 1x3PIN 3.81mm phoenix connector that supports up to 60W of power and is a
low-power solution. Use a 12V adapter to input voltage and a DC power supply to the outlet. If the voltage
used is greater than the recommended voltage, the system will not boot or even damage the motherboard.
Table 2.2: DC IN connector pin assignments
Pin
1
3

2.3.2 Ethernet port (LAN1/LAN2)

Table 3.1: Ethernet 10/100/1000 Mbps RJ-45 port
Pin
Signal
DC IN 12V
GND
10/100/1000BaseT Signal
Figure
2.10
Pin Signal
2 NC
Pin 10/100/1000BaseT Signal
16
User's Manual