2.1 Introduction
The following sections show the internal switch settings and the external connectors and pin assignments
for applications.
2.2 Switches
The KGEC-6301 edge controller has a number of switches inside the chassis that allows you to configure
your system to suit your application. The table below shows the function of each of the board's switches:
Switcher
CLEAR/CMOS
Clear CMOS Data Setting
AT/ATX
Set Power-on mode at AT or ATX
2.2.1 CLEAR/COMS -Clear CMOS Data
If you encounter the followings
a) CMOS data becomes corrupted.
b) You forget the supervisor or user password.
You can reconfigure the system with the default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Dial the dip switch to CLEAR mode, stay for 5~6 seconds, and then revert to CMOS mode;
4. Power-On the computer, press the Del key to enter the BIOS setting and reload the optimal default value;
5. Save and exit the Settings.
Name
Picture 2.1: CLEAR/COMS
14
User's Manual
Description
3-Pin switch
3-Pin switch