Table of Contents
Advertisement
Chapter 2
Haas Mini Mill Control Panel
Only the commands needed for operation are described.
Start Up
This section describes the main commands in order to start up the machine.
Start Up Procedure
♦ The main power switch on the principal rack of the PM must be on.
♦ Press on the POWER ON button of the Haas panel (#3 on the Haas panel above).
♦ Remove all ES that could be on.
♦ Wait that the ARL SMS mobile panel screen shows MILLING 1/2 : ROBOT
♦ Press on the POWER ON function touch of the Simatic mobile panel to switch on the AMP (#6 or )
on figure 2.1).
♦ Press on the RESET button as long as you have alarm message on the screen of the Haas panel (#9 on
the Haas panel above).
♦ Do a cycle door (open/close) of the PM.
♦ Press on the POWER UP - RESTART button to put the PM in origins position (#10 on the Haas panel
above).
♦ Press on the MEM button to select the memory mode (#11 on the Haas panel above).
2
Figure 2.2
User Manual - Haas Mini Mill
Machine Operation
1. Haas control panel
2. Screen
3. Power on button
4. Power off button
5. Emergency stop button
6. Handle jog
7. Cycle start button (Auto
mode)
8. Feed hold button (Auto
mode)
9. Reset button
10. Power up restart button
11. Memory mode button
Handle mode button.
12.
AA83766
Advertisement
Table of Contents
