HP Kayak XU03 Installation Manual page 10

CAUTION
HP Kayak XU 03xx PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Memory
Installing More Memory on the Video Adapter
Your PC Workstation is equipped with a video adapter that supports
2D and 3D graphics. If you need to have more video memory to display
more colors, higher resolutions, or for increased speed, you can install
more video memory on the video adapter.
To find out about available video memory upgrades, refer to the HP
World Wide Web Site at
http://www.hp.com/go/kayaksupport/
Static electricity can damage electronic components. Turn off all
equipment. Do not let your clothes touch the accessory.
To equalize the static electricity, rest the accessory bag on top of the
power supply while you are removing the accessory from the bag.
Handle the accessory as little as possible and with care.
To install a video memory module:
1 Switch off the display and computer, and disconnect the power
supply cables and any telecommunications cables. Remove the
computer's cover (refer to page 3) and carefully place the
PC Workstation on its side.
2 Carefully remove the board from the accessory slot, holding the
board at each end by its top edge. Do not bend the board. With its
components facing up, place the board on a clean, flat, solid,
static-free surface. Handle the board by its edges.
3 Attach the memory module to the connectors on the video adapter.
4 Replace the video adapter in the computer. Carefully slide the board
back into its accessory slot. Firmly press the board into the socket.
Make sure that the board slides into the socket completely and does
not touch components on other boards. Secure the video adapter.
5 Install any other accessories before replacing the cover (refer to
page 4). Reconnect all cables and power cords.
10 English