Installing A Second Hard Disk Drive In An Internal Shelf - HP XM600 - Kayak - 128 MB RAM User Manual

CAUTION
Installing the
New Drive
NOTE
Configure the new hard disk drive with the same settings as the old one.
1 Add the short blue guide rails to the new hard disk drive. Insert the guide
rail labeled "L" on the left-hand side (cable connectors facing towards
you and positioned at the bottom), and the guide rail "R" on the right-
hand side of the hard disk drive.
2 The hard disk drive can only be inserted one way. Ensure that the data
and cable connectors are facing you and positioned at the top.
3 Align the guide rails on both sides of the drive with the internal shelf
guides and then slide the drive in until it clicks into position.
4 Connect the power cable and the data cable to the new hard disk drive.
The connectors are shaped to go in one way only. If you are not sure
which connector to use, refer to "Installing Mass Storage Devices", on
page 32.
Avoid trapping or disconnecting the hard disk drive bay thermal sensor
cable. If this cable becomes disconnected, reconnect it to the system
board connector labeled T T T T H H H H E E E E R R R R M M M M A A A A L L L L _ _ _ _ S S S S E E E E N N N N S S S S O O O O R R R R (positioned near the IDE
and Floppy data cable connectors.
5 Replace the PC Workstation's cover (refer to page 25). Reconnect all the
power and telecommunications cables.
6 Turn to page 43 to complete the installation.

Installing a Second Hard Disk Drive in an Internal Shelf

The internal shelves can support two 3.5-inch devices. The master hard
disk drive must be installed in the top shelf when using an IDE
configuration.
To install a second hard disk drive:
1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover (refer to page 25 for instructions).
3 If the primary hard disk drive is installed in the top shelf, disconnect the
data and power cables.
4 Attach the short blue rails (found on the CD cage) to the new hard disk
drive. Insert the guide rail labeled "L" on the left-hand side (cable
connectors facing towards you and positioned at the bottom), and the
guide rail "R" on the right-hand side of the hard disk drive.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Installing a Second Hard Disk Drive in an Internal Shelf
37