HP Kayak XU03 Installation Manual page 9

8 The location of the memory module slots is shown here.
9 Slide the memory module into the slot at 90° to the system board
(with the cutouts furthest away from the processor).
Slide the memory module into the
o
slot at 90 to the system board
Push the module until the
retaining clips click into position
10 Firmly press the memory module completely into the connector
until the retaining clips click into position. Repeat this procedure for
each additional memory module you want to install.
11 Install any other accessories if necessary, then replace all units and
reconnect all cables and power cords. Replace the cover (refer to
page 4).
12 Check the HP Summary Screen to verify the new configuration.
HP Kayak XU 03xx PC Workstation — Installing Accessories In Your HP PC Workstation
Installing Memory
Memory module
cutouts
English
9