Table of Contents
Advertisement
9. SELECTING AND EXECUTING THE COUNTER FUNCTION
Downloaded from
ManualsNet.com
(1) Select any of the counter functions by writing a value to the lower 4 bits in the
upper bits of the remote register {address RWwm+2 (RWwm+A)}.
When the value set is other than the following set value, the initial value (count
disable function selection) is set.
However, when changing the counter function, make sure that the counter
function selection start command {RY(n+1)6 (RY(n+1)D)} and F.START terminal
are off.
Counter Function Selection
Count disable function
Latch counter function
Sampling counter function
Periodic pulse counter function
Address
15
RWwm+2(CH1)
RWwm+A(CH2)
External output hold・ clear setting
(Refer to Appendix 1)
(2) A selected function can be executed using the counter function selection start
command {RY(n+1)6 (RY(n+1)D)} or the F.START terminal (external input). The
signal input earlier is prioritized.
(3) Set the time for the sampling counter function and periodic counter function
between 1 and 65535 in 10ms increments.
The unit of time is 10 [ms] and the precision is less than 1 count.
Example: When 420 is set to the sampling/interval time setting area {address
RWwm+5 (RWwm+D)}
420×10=4200[ms]
POINT
The sampling and interval time values are set to the same address of the remote
register, but the value set is that of the function selected.
search engine
Set Value
Set in hexadecimal.
0
0
0
4 bits
Pulse input mode register
Counter function
selection register
(Refer to Sections 5.1, 5.2)
9 - 2
MELSEC-A
0
H
1
H
2
H
3
H
0
8 bits
Advertisement
Table of Contents
