Mitsubishi Electric AJ65BT-D62 User Manual page 4

[Installation Precautions]
 Use the module in an environment that conforms to the general specifications in the manual.
Otherwise, an electric shock, fire, misoperation or product damage or deterioration can occur.
 Securely fix the module using the DIN rail or mounting screws and fully tighten the mounting
screws within the specified torque range.
Undertightening can cause a drop or misoperation.
Overtightening can cause a drop or misoperation due to damaged screws or module.
 Do not touch the conductive areas of the module directly.
Otherwise, the module can misoperate or fail.
[Wiring Precautions]
 Before starting mounting, wiring or other work, always switch power off externally in all phases.
Otherwise, an electric shock, product damage or misoperation may occur.
 When switching power on or starting operation after mounting, wiring or other work, always
install the supplied terminal cover to the product.
Otherwise, you may get an electric shock.
 Be sure to shut off all phases of the external power supply used by the system before
installation or wiring.
Not doing so can cause the product to be damaged or malfunction.
 Ground the FG terminal to the protective ground conductor dedicated to the programmable
controller.
Failure to do so may result in electric shock or malfunction.
 Use applicable solderless terminals and tighten them with the specified torque. If any solderless
spade terminal is used, it may be disconnected when the terminal screw comes loose, resulting
in failure.
 Before wiring the module, confirm the rated voltage and terminal arrangement of the product.
A fire or failure can occur if the power supply connected is different from the rating or wiring is
incorrect.
 Tighten the terminal screws within the specified torque range.
Undertightening can cause a short circuit or misoperation.
Overtightening can cause a short circuit or misoperation due to damaged screws or module.
 Ensure that foreign matters such as chips and wire off-cuts do not enter the module.
They can cause a fire, failure or misoperation.
Downloaded from ManualsNet.com search engine
CAUTION
WARNING
CAUTION
A - 2