ADEMCO VISTA-10SE Installation Instructions Manual page 57

Hide thumbs Also See for VISTA-10SE:
Table of Contents

Advertisement

www.PDF-Zoo.com
Default Descriptor ↓
ZN 0 1
ZO NE 0 1
Flashing Cursor (system is
ready for entry of word).
ZN 0 1
A
Flashing Cursor
ZN 0 1
B A CK
ZN 0 1
BA CK
A
Flashing Cursor if "6" is
pressed (system is
ready for next word).
ZN 0 1
BA CK
D O O R
Flashing Cursor
– 57 –
firealarmresources.com
4. Press "0" (No).* The system will then
automatically display the default
descriptor for zone 1.
*
The procedure for adding custom words to
the built-in vocabulary will be found later
under "Adding Custom Words".
If a descriptor was not entered previously
for zone 1, the default descriptor for zone
1 will be displayed.
Note that no entries can be made. Entries
can be made only when the display
contains a flashing cursor, which signifies
the "entry mode".
5. To delete or change the default
descriptor for zone 1, press [
the same zone number (01). This will
clear that descriptor and gain access to
the entry mode with flashing cursor,
allowing changes to be made.
NOTE: If you do not wish to change the
existing descriptor for zone 1, enter [
plus the next zone number for which
you wish to enter (or check) a
descriptor. A summary display for that
zone will appear. You must then press
[
plus the same zone number again
]
to gain access to the entry mode
(flashing cursor) for that zone.
6. Press # plus 3-digit number for the
first
word
from
VOCABULARY LIST" on a following
page. Example: The descriptor that we
wish to enter for zone 1 is BACK
DOOR. From the list, BACK = 013.
Therefore, you would enter # 0 1 3.
Note: If you accidentally enter the
wrong word, simply press # plus the
correct 3-digit number for the word you
want.
7. Press "6" to accept the selected
word and continue.
Note: If this is the only word you are
using for the descriptor, press "8"
instead of " 6 " to save that word in
memory, and then go to step 11.
8. Enter the 3-digit number for the next
word. In our example, the word is
DOOR, whose number is "057".
Enter # 0 5 7. This display will appear:
plus
]
]
the
"ALPHA

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vista-2000

Table of Contents