Using The Built-In Flash - Canon PowerShot Pro 90 IS Software Starter Manual

Using the Built-In Flash

Use the built-in flash according to the guidelines below.
(Auto)*
(Red-eye reduction, Auto)
(Red-eye reduction, Flash on)
(Flash on)
(Flash off)
* No icon appears in the display panel in Auto mode.
Built-in Flash Settings
The flash cannot be used with some shooting modes.
(Auto)
(Red-eye reduction,
Auto)
(Red-eye reduction,
Flash on)
(Flash on)
(Flash off)
* Default setting.
Setting selection is possible.
Setting can only be selected for the first image.
- Setting selection is not possible.
44
Shooting - Letting the Camera Select Settings
The flash fires automatically as required by the lighting level.
The red-eye reduction lamp always fires but the flash only fires as
required by the lighting level.
The red-eye reduction lamp and the flash always fire.
The flash always fires.
The flash does not fire.
Press the
1
flash modes.
• The selected flash mode will show in the
display panel. It will also appear in the LCD
monitor or viewfinder if it is on.
Shoot the image.
2
• When the flash is set to fire, it will
automatically pop up when the shutter button
is pressed halfway and a red
the LCD monitor or viewfinder.
• Shooting procedures are described in steps 6-8
in the Quick Start section (p. 9).
• To close the flash, press it down with your
fingers.
*
* *
-
-
*
button to switch between
* -
-
* -
-
- -
-
*
*
will appear in
- - - -
- - - -
* * * *