Continuous Mode - Canon PowerShot Pro 90 IS Software Starter Manual

Continuous Mode

Use this mode to shoot successive frames while the shutter button is pressed.
• This mode cannot be selected in the
• An externally mounted flash will not fire in this mode.
• The built-in flash can be used, but the interval between images will lengthen to
accommodate the flash recharge time.
• Successive frames can be shot until the CF card is filled.
• The interval between frames may lengthen somewhat when the internal memory
gets full.
• Turning the camera off cancels the setting.
54
Shooting - Letting the Camera Select Settings
Press the
1
• Press the
the icon in the display panel. The icon will
also appear in the LCD monitor or viewfinder if
it is on.
• You can cancel the continuous mode by
pressing the
disappears.
Shoot the image.
2
• While the shutter button is pressed all the way,
shots are taken at approximately 0.7 images
per second* when the image quality is set to
Large / Fine. Release the shutter button to stop
shooting.
*
This figure reflects standard shooting conditions
established by Canon. Actual figures may vary
according to the subject and shooting conditions.
• The shooting procedures are the same as those
described in steps 6-8 in the Quick Start section
(p. 9).
,
button.
button several times to display
button until the
or shooting mode.
icon