Consecutive Scanning Mode - Inateck BCST-55 Instruction Manual

5s

Consecutive Scanning Mode

You don't need to push the button to trigger scanning under this mode. The red LED is on
automatically and ready to scan a barcode. If no barcodes are scanned, the red LED will stay
on. After a successful scanning, the red LED goes off first and becomes lit again
automatically.
To adjust the scanning intervals, please follow the steps below:
For example: to set the scanning mode as "Consecutive Scanning Mode" and set the
"Consecutive Scanning Interval" as 1s.
1. Read the "Enter Setup" barcode.
2. Read the "Consecutive Scanning Mode" barcode.
3. Read the "Consecutive Scanning Interval Setting" barcode.
4. Read the "1s" barcode.
5. Read the "Exit and Save" barcode.
Consecutive Scanning Mode
400ms
1s
Enter Setup
Consecutive Scanning Interval Setting
Exit and Save
50s
800ms
(*) 2s
16