Safety Information - Abexo 051D User Manual

WARNINGS FOR THE INSTALLER - GENERAL SAFETY INSTRUCTIONS
1. Read the instructions carefully before installing the con-
trol unit.
2. Keep these instructions for future reference.
3. This product has been designed and manufactured
exclusively for the use intended and indicated in this
documentation. Any other use not expressly indicated
could compromise the integrity of the product and/or
constitute a source of danger.
4. For the safety of all persons, the instructions given in
this manual must be carefully followed. Incorrect instal-
lation or use of the product can cause serious personal
injury.
5. Packaging materials must not be left within the reach
of children, as they are potential sources of danger, and
must be properly disposed of.
6. AB Tecno Srl declines all responsibility for any conse-
quences arising from improper use or use other than
that for which the device was designed and con-
structed.
7. AB Tecno Srl shall not be held liable for non-complian-
ce with current EC standards in the construction of the
motorised closing device, or for any deformation that
may occur during use.
8. Do not install the appliance in an explosive atmosphere:
the presence of flammable gases or fumes constitutes a
serious safety hazard.
9. Installation must be carried out in accordance with
standards EN 12453 and EN 12445. For non-EU coun-
tries, in order to achieve a sufficient and adequate level
of safety, the above-mentioned standards must be ob-
served in addition to the individual national regulatory
references.
10. Before carrying out any work on the system, discon-
nect any batteries and switch off the power supply.
11. An omnipolar switch with contact opening distance
equal to or greater than 3 mm should be installed on
the power supply of the automatic gate. The use of a 6A
thermomagnetic circuit breaker with omnipolar switch
is recommended.
USER MANUAL - 230 VAC MULTIFUNCTION CONTROL UNIT - 051D
12. Check that there is a differential switch with a 0.03A
threshold upstream of the system.
13. Check that the earthing system is properly installed
and connected to the metal parts of the enclosure.
14. Also the correct operation of the automated devices
with an internal anti-crushing safety function must be
checked in accordance with the standards indicated in
point 9.
15. The safety devices (standard EN 12978) protect any
danger areas from mechanical risks related to move-
ment, such as crushing, dragging, shearing and lifting.
16. For each system, we recommend the use of at least
one warning light (e.g. flashing light), as well as an ap-
propriately fixed and clearly visible warning sign.
17. AB Tecno Srl declines all responsibility concerning the
safety and proper operation of the automatic gate, in
the event that components not manufactured by AB
Tecno Srl are used when installing the system.
18. The installer must provide the End User with all infor-
mation concerning manual operation of the automatic
gate in the event of an emergency.
19. Do not allow children or other persons to stand near
the system during operation.
20. Keep any remote control or triggering device out of
the reach of children to prevent unintentional opera-
tion of the automatic gate.
21. The transit of people and vehicles is only permitted
when the automatic gate is fully open.
22. The user of the automatic gate must refrain from any
attempt at repair and/or direct intervention and must
contact qualified personnel only. Otherwise, AB Tecno
Srl declines all liability for any consequences.
23. Anything not expressly provided for and indicated in
these instructions is not permitted.
3