Table of Contents
Advertisement
ALL EXAMPLES ASSUME THAT THE PLUG-IN RELAY EXPANSION MODULE (APE 570/0022) HAS BEEN CONNECTED TO THE CONTROL
UNIT'S OUTPUT PINS.
EXAMPLE: remote control configuration for controlling a light
1. Store a remote control as
r6
2. Select the parameter
3. Press and hold down the (-) KEY on the control unit. The display starts flashing showing
r6
4. When the display shows
5. Using the (+)(-) KEYS, select the
(←) (→) KEYS
6. Using
select the parameter
7. Using the (+)(-) KEYS, select the
(←) (→) KEYS
8. Exit the menu using the
The remote control stored by performing this procedure will switch the output status without changing the gate status.
EXAMPLE: configure a remote control to signal a dead man opening movement
1. Store a remote control as
r6
2. Select the parameter
3. Press and hold down the (-) KEY on the control unit. The display starts flashing showing
r6
4. When the display shows
5. Using the (+)(-) KEYS, select the
(←) (→) KEYS
6. Using
select the parameter
7. Using the (+)(-) KEYS, select the
←) (→) KEYS
8. Exit the menu using the
When the remote control button, stored following the above procedure, is transmitting, the gate will move in the OPEN direction and
simultaneously the output will be activated.
EXAMPLE: configure a remote control to signal a dead man closing movement
1. Store a remote control as
r7
2. Select the parameter
3. Press and hold down the (-) KEY on the control unit. The display starts flashing showing
r7
4. When the display shows
5. Using the (+)(-) KEYS, select the
(←) (→) KEYS
6. Using
select the parameter
7. Using the (+)(-) KEYS, select the
(←) (→) KEYS
8. Exit the menu using the
When the remote control button, stored following the above procedure, is transmitting, the gate will move in the CLOSE direction and
simultaneously the output will be activated.
EXAMPLE: transforming a 230VAC light into a intermittent flashing light
(←) (→) KEYS
1. Using
select the parameter
2. Using the (+)(-) KEYS, select the
(←) (→) KEYS
3. Exit the menu using the
The lamp will turn on and off quickly during opening, slowly during closing and will remain on during the AUTO-CLOSE TIME.
PROGRAMMABLE OUTPUTS
r6
.
again.
without flashing, release the (-) KEY.
do
function.
o1
o2
/
.
05
function.
.
r6
.
again.
without flashing, release the (-) KEY.
Po
function.
o1
o2
/
.
06
function.
.
r7
.
again.
without flashing, release the (-) KEY.
Pc
function.
o1
o2
/
.
08
function.
o1
o2
/
.
03
function.
USER MANUAL - 230 VAC MULTIFUNCTION CONTROL UNIT - 051D
r6
.
r6
.
r7
.
26
Advertisement
Table of Contents
