Titan TTI866JSW Original Instructions Manual page 28

Product functions
EN EN
Bevel angle
WARNING! Remove the battery (5) from the machine (see Removing
the battery) before making any adjustments. Risk of personal injury.
To adjust base plate, loosen screw
with the hex key (7) provided, slide the
base plate (10) slightly forward towards
the front of tool, then rotate to desired
angle. (Fig. 12). The detent slots will
there are additional position marks for
15° and 30° angles. The number of
degrees to be set is engraved on the
base plate. Slide the base plate back
to the front until the teeth engage. After
positioning the base plate securely
tighten screw. Check that the base
plate is secure.
battery).
Parallel guide
The rip fence can be fastened on both sides of the device.
WARNING! Remove the battery (5) from the machine (see Removing
the battery) before making any adjustments. Risk of personal injury.
1. Loosen the locking screws (20) for the parallel
guide (19). Make sure not to unscrew the
locking screws completely.
2. Slide the parallel guide (19) into the slot with
the scale pointing up.
3. Move the parallel guide (19) to the desired
position.
4. Tighten the locking screws (20) for parallel
guide.
5.
28
MNL_18V CORDLESS JIGSAW KIT_MJS18-Li_V1_211222.indd 28
10
7
Fig. 12
20
TTI866JSW
19
Fig. 13
2021/12/22 1:37 PM