Table of Contents
Advertisement
Before you start
EN
Saw blade
WARNING! Always use saw blades according to the intended use!
For example, never use a saw blade intended for working on wood for
working on metal or vice versa!
Observe the technical requirements of this product (see section
Some driver bits become hot during use! Handle them carefully! Wear
protective gloves when handling driver bits in order to avoid injuries
like burns!
Selecting the saw blade
Only T shank saw blades can be used with the product.
Inserting
1. Unlock the saw blade holder (15) by turning the blade clamp lever (15a) in an
anti-clockwise direction and hold it in position (Fig. 1, step 1).
NOTE: Clean the shank of the saw blade (17 / 18) before inserting it.
2. Align and insert the saw blade into the saw blade
holder (15) to the stop (Fig. 1, step 2).
3. Release the locking sleeve (15a). It must turn
back completely and make sure the saw blade
4. Make sure that the saw teeth always point to front.
5. Make sure when inserting the saw blade that the
back of the saw blade is in the groove on the
guide roller (14).
6. Check that the saw blade is seated securely by
pulling the saw blade. A loose saw blade can fall
out and lead to injuries.
Replacing / Removing
1. Unlock the saw blade holder (15) by turning the locking sleeve (15a) in an
anti-clockwise direction and hold it in position. (Fig. 2).
2. Firmly grasp the saw blade to avoid the ejection of the saw blade caused by
the inner spring force.
22
MNL_18V CORDLESS JIGSAW KIT_MJS18-Li_V1_211222.indd 22
U type
T type
15
15a
Fig. 1
TTI866JSW
1.
14
2.
2021/12/22 1:37 PM
Advertisement
Table of Contents
