Programming; A) Universal Access, Resetting Codes; B) Optical And Acoustic Indication - Renkforce 751781 Operating Instructions Manual

9. Programming

You can now program your code lock to suit your personal requirements. This chapter
explains all the programming possibilities.
Note:
You should not take longer than 10 seconds between each keypad operation, otherwise
the previous keypad entries will be deleted.

a) Universal access, resetting codes

If you have forgotten your master code, or it no longer seems to function, then perform
the following steps.
• Remove your code lock from the power supply
• Move jumper DAP (2) from "OFF" to "ON"
• Reconnect the main power supply to your code lock (a permanent beep sounds)
• Now move jumper DAP (2) from "ON" to "OFF"
(the beep stops). The master code has now been reset to "0000".
• You are now in programming mode and can make all required settings. You can find
these settings in the "Programming possibilities" chapter towards the end of these
Instructions, or at the end of the different language sections.

b) Optical and acoustic indication

Status:
1. In programming mode
2. Keypad operation
3. Correct code entry
4. Falsche Code-Eingabe
5. The DAP jumper is "ON"
when the power is connected
6. Stand-by mode
48
Beeper:
Off
1 x beep
2 x beep
5 x beep
Permanent beeping
by the base station
Off
Green LED (2):
Lights up
1 x flash
2 x flash
5 x flash
Flash every
two seconds
Flash every
two seconds