B) Mounting - Renkforce 751781 Operating Instructions Manual

b) Mounting

Choose a suitable location for your code lock that allows the system to be easily oper-
ated.
Use a suitable screwdriver to remove the screws from the mounting holes (9) of the
control unit.
Remove the cover from the rear of the control unit.
Use the holes in the cover as a drilling template and mark the position of the mounting
holes.
Make sure that there are no electric wires, water pipes, or similar systems
behind where you will be drilling.
Remove the cover and drill the mounting holes.
Lay all cables required, depending on the intended use.
The cables can be fed through the round opening in the cover. Punch these out with a
tool if required.
Screw the cover into position using the screws provided. Use dowels if required.
Make sure that no-one can trip over the cables.
40