Renkforce 751781 Operating Instructions Manual page 60

Changing the existing programming
This chapter provides a brief description of how you can change the programmed set-
tings (set in the programming example)
Please refer to the "Programming explanation" section for a detailed description.
3 1 8 9
4 1 #
7 1 #
8 3 #
9 0 #
*
8 3 2 1
Enter user code 1 and open the door.
In this case, no alarm is triggered.
If the door remains open for longer than 60 seconds then the alarm sounds. Just close
the door to switch off the alarm.
60
Programming mode
*
Relay 1 with ON/OFF function controlled by user
code 1
After entry of 10 wrong codes, terminal (16)
"DURESS" switches to ground
Input melody when the connection between the
"DOOR SENS" and "ground" terminals is inter-
rupted
Door delay alarm is switched off
End of programming
Relay 1 toggles