Table of Contents
Advertisement
Installation
4.2.2
Adjusting the downward tilt angle.
NOTE!
The tilt angle must be set at 90° to the vehicle body
before the downward tilt angle is adjusted (see pre-
vious page).
m
WARNING!
To ensure that the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max. 10° if there
are going to be people on the platform.
1. Raise the lift to the vehicle floor. See illustration.
2. Loosen the lock screw of the end stop (2). Screw
the end stop all the way back towards the platform
(3). See illustration.
3. Tilt the platform down to max. 10 degrees below
the horizontal. See illustration.
4. Adjust the end stop all the way to the top of the
cylinder (4).
5. Tighten the lock screw in the end stop (5). See
illustration.
The tightening torque for lock screws is between 3-5 Nm.
Test all functions.
m
WARNING!
The tilt angle of both cylinders must be adjusted to be the
same, otherwise they may be damaged.
www.zepro.com
Adjusting collar
Lock screw
Bolt
Washer
Image 42. Tilt cylinder
ZAHD, ZAEHD 150/200-155/175
Image 40. The tilt angle must be ad-
justed to max.10º down
2
5
3
4
Image 41. End stop with lock screw
End stop
27
Advertisement
Table of Contents
