Safety Instructions; Removal From Service / Correct Disposal Of The Trace Do Measurement System - Thermo Scientific AquaSensors AquaTrace User Manual

 Observing all warnings and cautions in the documentation regarding all products used in this
measurement system, including the sensor, mounting hardware, AV38 electronics and
cabling.
 Observing the prescribed environmental and operational conditions.
 Observing chemical compatibility with all wetted materials.

1.3 Safety Instructions

The Trace DO Measurement System should be installed and operated only
by personnel familiar with the sensor and qualified for such work.
A defective Trace DO Measurement System should be returned to Thermo
Fisher Scientific for repair or replacement. Contact Thermo Fisher Scientific to
obtain a Return Material Authorization (RMA) number.
No modifications to the Trace DO Measurement System are allowed. The
manufacturer/supplier accepts no responsibility for damage caused by unauthorized
modifications. The risk is borne entirely by the user.
1.4

Removal from Service / Correct Disposal of the Trace DO Measurement System

Removal from Service
1.
2.
3.
4.
5.
6.
7.
8.
Correct Disposal of Unit

Thermo Scientific AquaSensors
Shut off the process sample connection to the AquaTrace system.
Disconnect the power supply to the AquaTrace system.
Disconnect any cable wiring from the AquaTrace analyzer's outputs.
Disconnect the process connections to the AquaTrace system.
Remove the sensor from the flow chamber.
Rinse the sensor head with clean water and replace the storage cap on the end of the AquaTrace sensor.
Rinse the inside of the flow chamber with clean water and allow it to dry.
Replace the sensor inside the flow chamber.
When the Trace DO Measurement System is taken out of service, observe the local environmental
regulations for correct disposal.
™
AquaTrace
™
Trace DO System User Guide
5