Thermo Scientific AquaSensors AquaTrace User Manual page 13

Tools and Equipment required for installation:
Panel Mounting Instructions:
1. Place the 12 inch x 12 inch pane on the wall where it is to be mounted and mark the placement
2. Drill a mounting hole for the upper left corner with a masonry drill bit and install a wall anchor.
3. Mount the AquaTrace panel with the upper left mounting bolt.
4. Using a level, rotate the panel until the top edge is level, then mark the remaining three
5. Rotate the AquaTrace panel out of the way, drill the three mounting holes and install wall
6. Secure the panel with all four bolts and washers and tighten.
Thermo Scientific AquaSensors
 ½ inch drill with drill bits for appropriate wall anchor
 Four ¼ inch diameter bolts – 1.5 inches long
 Four ¼ inch flat washers
 Adjustable wrench
 ¼ inch tubing
 Pressure / flow regulating valve
 Shut-off valve
 Standard screw driver
of the upper left hole.
mounting holes.
anchors.
™
AquaTrace
™
Trace DO System User Guide
11