Table of Contents
Advertisement
Chapter 3 Basic Operations — Operating with the remote control
Switching the image aspect ratio
Switch the image aspect ratio according to the input.
button
1)
Press the <ASPECT> button.
f The setting will change each time you press the button.
Note
f Refer to the [POSITION] menu → [ASPECT] ( x page 69) for details.
Using the function button
By assigning the following functions to the <FUNCTION> button, it can be used as a simplified shortcut button.
[SUB MEMORY], [SYSTEM SELECTOR], [DAYLIGHT VIEW], [WAVEFORM MONITOR]
button
1)
Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] ( x page 105).
Displaying internal test pattern
The projector has eight types of internal test patterns to check the condition of the projector body. To display test
patterns, perform the following steps.
button
1)
Press the <TEST PATTERN> button.
2)
Press qw to select the test pattern.
Note
f Test patterns can also be displayed using the menu operation. Refer to "[TEST PATTERN] menu" ( x page 113) for details.
f Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal before performing
various adjustments.
Using the status function
Display the status of the projector.
button
1)
Press the <STATUS> button.
f The [STATUS] screen is displayed.
54 - ENGLISH
Advertisement
Table of Contents
