Table of Contents
Advertisement
Setting the projector
1)
Connect the projector to a computer using a LAN cable.
2)
Turn on the power of the projector.
3)
Press the <MENU> button to open the [NETWORK] menu from the main menu.
f The [NETWORK] screen is displayed.
4)
Press as to select [WIRED LAN], and press the <ENTER> button.
f The [WIRED LAN] screen is displayed.
5)
Perform the [WIRED LAN] setting.
f Refer to [WIRED LAN] ( x page 122) for details.
Note
f To connect to an existing network, perform after consulting your network administrator.
r Factory default setting
f Following setting has been made as a factory default.
[DHCP]
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
[DNS1]/[DNS2]
Operating the computer
1)
Turn on the power of the computer.
2)
Perform the network setting following the instruction of your network administrator.
f Operation from the computer is possible by configuring the network setting of the computer as follows if the
projector is in the factory default setting.
[IP ADDRESS]
[SUBNET MASK]
[DEFAULT GATEWAY]
132 - ENGLISH
Chapter 5 Operations — Network connection
OFF
192.168.0.8
255.255.255.0
192.168.0.1
None
192.168.0.10
255.255.255.0
192.168.0.1
Advertisement
Table of Contents
