Table of Contents
Advertisement
[E-mail set up] page
E-mail can be sent to preset E-mail addresses (up to two addresses) periodically or when an error or problem has
occurred.
Click [Detailed set up] → [E-mail set up].
1
[ENABLE]
Select [ENABLE] to use the E-mail function.
2
[SMTP SERVER NAME]
Enter the IP address or the server name of the E-mail server
(SMTP). To enter the server name, the DNS server needs to be
set up.
3
[MAIL FROM]
Enter the E-mail address of the projector. (Up to 63 characters in
single byte)
4
[MEMO]
Enter information such as the location of the projector that notifies
the sender of the E-mail. (Up to 63 characters in single byte)
7
[E-MAIL ADDRESS 1], [E-MAIL ADDRESS 2]
Enter the E-mail address to be sent. Leave [E-MAIL ADDRESS 2]
blank when two E-mail addresses are not to be used.
8
Settings of the conditions to send E-mail
Select the conditions to send E-mail.
[MAIL CONTENTS]:
Select either [NORMAL] or [SIMPLE].
[ERROR]:
Send an E-mail when an error occurred in the self-diagnosis.
[INTAKE AIR TEMPERATURE]:
Send an E-mail when the intake air temperature has reached the
value set at the above field.
[PERIODIC REPORT]:
Place a check mark on this to send an E-mail periodically.
It will be sent on the days and time with the check mark.
9
[Submit]
Update the settings.
Chapter 5 Operations — Web control function
7
8
5
[MINIMUM TIME]
Change the minimum interval for the temperature warning E-mail.
The default value is 60 minutes. In this case, another E-mail will
not be sent for 60 minutes after sending the temperature warning
E-mail even if it reaches the warning temperature.
6
[INTAKE AIR TEMPERATURE]
Change the temperature setting for the temperature warning
mail. A temperature warning E-mail is sent when the temperature
exceeds this value.
1
2
3
4
5
6
7
8
9
ENGLISH - 141
Advertisement
Table of Contents
