Release L.10.25 Enhancements; Release L.10.26 Enhancements; Release L.10.27 Enhancements - HP ProCurve J8766A Release Note

To configure the source IP address for a generated trap pdu, enter this command.
Syntax: [no] snmp-server trap-source [ IP-ADDR | loopback<0-7>]
Allows you to specify the source IP address for the trap pdu. The no form of
the command resets the switch to the default behavior (compliant with rfc-
1517).
Default: Interface IP address
IP-ADDR: The user-specified IP address that will be used as the source IP
address in the generated trap.
loopback <0-7>: The IP address configured for the specified loopback interface
will be used as the source IP address in the generated trap pdu. In the case
of multiple addresses, the lowest alphanumeric address will be used.
Note
The snmp-server response-source and snmp-server trap-source commands configure the source IP
address for IPv4 interfaces only.
The show snmp-server command displays the policy configuration.

Release L.10.25 Enhancements

Release L.10.25 includes the following enhancement:
Enhancement (PR_1000376626) - Enhanced CLI qos dscp-map help and show dscp-map
■
text to warn user that inbound classification based on DSCP codepoints only occurs if qos
type-of-service diff-services is also configured.

Release L.10.26 Enhancements

Software fixes only; no new enhancements; never released.

Release L.10.27 Enhancements

Software fixes only; no new enhancements.
Enhancements
Release L.10.25 Enhancements
65