Software Fixes In Release L.10.01 - L.11.09; Release L.10.02 - HP ProCurve J8766A Release Note

Software Fixes in Release L.10.01 - L.11.09

Release L.10.02

Software Fixes in Release L.10.01 - L.11.09
Software fixes are listed in chronological order, oldest to newest software release. To review the list
of fixes included since the last general release that was published, begin with
page 114.
Unless otherwise noted, each new release includes the fixes added in all previous releases.
Release L.10.01 was the first software release for the ProCurve 4200vl Series.
Release L.10.02
Problems Resolved in Release L.10.02
■ Crash/802.1X (PR_1000302284) — When 802.1X and MAC Authentication are both
configured, the switch may crash with a message similar to:
"SubSystem 4096 went down: 01/01/90 00:22:09 NMI event
SW:IP=0x003870a4 MSR:0x0024b032 LR:0x203081b0 Task='mWebAuth' Task
ID=0x12b4fa8 cr: 0x42000220 sp:0x012b6be8 xer:0x0100000f".
■ Crash/Stacking (PR_1000297510) — When using Web User Interface and the switch is
commander for stacking, the switch may crash with a message similar to:
PPC Bus Error exception vector 0x300: Stack-frame=0x01731de8 HW
Addr=0x02800007 IP=0x0022dc30 Task='tHttpd' Task ID=0x1731fb0 fp:
0x0167d180 sp:0x01731ea8 lr:0x
IGMP (PR_1000301557) — Data-driven IGMP requires an IP address on a VLAN to work
■
properly.
■ IP Forwarding (PR_1000305739) — When a user attempts to configure 'ip forward-
protocol netbios-dgm', the switch incorrectly configures 'ip forward-protocol netbios-ns'
instead.
■ LACP (PR_ 1000302457) — Although default behavior is LACP disabled on all ports, upon
boot, the switch event log reports, "lacp: Passive Dynamic LACP enabled on all ports".
■ MSTP Enhancement (PR_1000314692) — Added new commands: "spanning-tree legacy-
path-cost" and "spanning-tree legacy-mode". See
18 for details.
■ QoS (PR_1000304105) — Maximum QoS rules limit is incorrect, internal to the switch.
Setup (PR_1000301498) — Manual IP address cannot be set when using the "setup" menu.
■
106
"MSTP Default Path Cost Controls" on page
"Release L.10.25" on