HP ProCurve J8766A Release Note page 108

Enhancements
Release L.11.08 Enhancements
ProCurve(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+------------------------------------------------
1 | * * *
2 |
3 |
Figure 7. An Example of the show config files Command Output
2. To save a configuration file for software version K.12.43, enter this command:
ProCurve(config)# copy config config1 config configK1243.cfg
You can choose any name for the saved configuration file that you prefer.
3. Display the configuration files as shown in Figure 8. You will see your newly created configu-
ration file listed.
ProCurve(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+------------------------------------------------
1 | * * *
2 |
3 |
Figure 8. A Config File for the Current Software Version is Created
4. Now update your switch to the desired version, for example, K.12.51. Enter the show flash
command to see the results. The switch is now running the software version K.12.51.
ProCurve(config)# show flash
Image Size(Bytes)
----- ----------
Primary Image : 6771179
Secondary Image : 7408949
Boot Rom Version: K.12.12
Default Boot : Primary
Figure 9. Show Flash Command after Upgrading the Switch to a New Version of the Software (K.12.51)
5. If you want to run the prior software version, K.12.43 in this example, enter this command:
ProCurve(config)# boot system flash secondary config configK1243.cfg
102
| config1
| config2
|
| config1
| config2
| configK1243.cfg
Date
-------- -------
10/15/07 K.12.51
08/24/07 K.12.43
Version