Adding Snmpv3 Users With Aes - HP ProCurve J8766A Release Note

Enhancements
Release L.10.20 Enhancements
ProCurve# show instrumentation monitor configuration
PARAMETER
------------------------- ---------------
mac-address-count
ip-address-count
system-resource-usage
system-delay
mac-moves/min
learn-discards/min
ip-port-scans/min
arp-requests/min
login-failures/min
port-auth-failures/min
SNMP trap generation for alerts: enabled
Instrumentation monitoring log : enabled
Figure 28. Viewing the Instrumentation Monitor Configuration

Adding SNMPv3 Users With AES

To use SNMPv3 on the switch, you must configure the users that will be assigned to different groups.
To configure SNMP users on the switch:
Configure users in the User Table with the snmpv3 user command. To view the list of configured
1.
users, enter the show snmpv3 user command.
Assign users to Security Groups based on their security model with the snmpv3 group command.
2.
Refer to the chapter titled "Configuring for Network Management Applications" in the Management
and Configuration Guide for your switch for details on adding SNMPv3 users.
C a u t i o n
If you add an SNMPv3 user without authentication and/or privacy to a group that requires either
feature, the user will not be able to access the switch. Ensure that you add a user with the appropriate
security level to an existing security group.
To configure an SNMPv3 user, you must first add the user name to the list of known users with the
snmpv3 user command.
60
LIMIT
1000 (med)
1000 (med)
50 (med)
5 (high)
100 (med)
100 (med)
10 (med)
100 (low)
10 (med)
10 (med)