Release L.10.26
Problems Resolved in Release L.10.26
■
IP Connectivity (PR_1000418378) — The switch incorrectly updates its ARP table when
a client, which is configured with a valid IP address for a valid VLAN, is connected to a port
in another VLAN on the switch. This will result in loss of connectivity for the valid client in
the appropriate VLAN.
■
Crash (PR_1000410959) — If the SNMPv3 user is deleted on the switch without deleting
associated parameters and is then rebooted, the switch may reboot continuously giving a
software exception error similar to:
Software exception at exception.c:373 -- in 'mSnmpEvt', task ID =
0x17d1818 -> Memory system error at 0x17c22e0 - memPartFree
sFlow (PR_1000396889) — If sFlow skip count is set greater than the maximum skip count
■
or less than the minimum skip count, the switch returns an error. This will prevent PCM from
collecting sampling data.
Crash (PR_1000421322) — When issuing config-related CLI commands (such as show run
■
or show tech) or when PCM attempts to retrieve the configuration file via TFTP from a switch
having a large configuration file, the switch may crash with a message similar to:
Software exception at exception.c:373 -- in 'tTftpDmn', task ID =
0x11cfaa8 -> Memory system error at 0x1175550 - memPartFree
Web UI (PR_1000421206) — Web UI freezes when logging-in.
■
Release L.10.27
Problems Resolved in Release L.10.27
802.1x (PR_1000446227) — The 802.1x authentication running over PAP access does not
■
work if the RADIUS message authenticator attribute is required.
Release L.10.28
Problems Resolved in Release L.10.28
■
MSTP (PR_1000439775) — The switch generates an MSTP topology change when a port
goes off-line when all ports are set to be an auto-edge-port.
Crash (PR_1000445461) — Setting interface 16 of the J8764A module to non-AUTO will
■
cause the module to repeatedly crash with a message similar to:
Slot B Bus error:
Task ID=0x41cbca04fp:0x41cbc7e4 sp:0x41cb
HW Addr=0x70000000 IP=0xe59ff018 Task='mPmSlvCtrl'
Software Fixes in Release L.10.01 - L.11.09
Release L.10.26
115
Need help?
Do you have a question about the ProCurve J8766A and is the answer not in the manual?
Questions and answers