HP ProCurve J8766A Release Note page 29

The show sflow destination command includes information about the management-station's destina-
tion address, receiver port, and owner.
ProCurve# show sflow destination
sflow
Datagrams Sent
Destination Address
Receiver Port
Owner
Timeout (seconds)
Max Datagram Size
Datagram Version Support
Figure 4. Example of Viewing sFlow Destination Information
Note the following details:
Destination Address remains blank unless it has been configured on the switch via SNMP.
■
■ Datagrams Sent shows the number of datagrams sent by the switch agent to the manage-
ment station since the switch agent was last enabled.
Timeout displays the number of seconds remaining before the switch agent will automati-
■
cally disable sFlow (this is set by the management station and decrements with time).
■ Max Datagram Size shows the currently set value (typically a default value, but this can
also be set by the management station).
The show sflow sampling-polling command displays information about sFlow sampling and polling on
the switch. You can specify a list or range of ports for which to view sampling information.
ProCurve# show sflow sampling-polling 1-5
sflow destination Enabled
Port | Sampling
Enabled
----- + -------
1 | Yes
2 | No
3 | Yes
4 | Yes
5 | Yes
Figure 5. Example of Viewing sFlow Sampling and Polling Information
The show sflow all command combines the outputs of the preceding three show commands including
sFlow status information for all the ports on the switch.
Enabled
221
10.0.10.41
6343
admin
333
1400
5
Rate Header Samples
-------- ------ ---------- + ------- --------
6500000 128
50 128
2000 100
200 100
20000 128
Dropped | Polling
| Enabled
5671234 Yes
0 Yes
24978 No
4294967200 Yes
34 Yes
Enhancements
Release L.10.06 Enhancements
Interval
60
300
30
40
500
23