Back Of The Switch; Console Port; Power Connector - HP ProCurve 2650 Install Manual

Introducing the HP Procurve Switch 2650

Back of the Switch

Back of the Switch

Console Port

This port is used to connect a console to the Switch 2650 by using the serial
cable supplied with the switch. This connection is described under "Connect
a Console to the Switch" in chapter 2, "Installing the Switch". The console can
be a PC or workstation running a VT-100 terminal emulator, or a VT-100
terminal.

Power Connector

The Switch 2650 does not have a power switch; it is powered on when
connected to an active AC power source. The switch automatically adjusts to
any voltage between 100--240 volts and either 50 or 60 Hz. There are no voltage
range settings required.
1-6
Cooling vent - make sure this is not
obstructed for proper switch operation
Console
Console Port
AC power connector