Download Print this page

HP ProCurve 2650 Install Manual: Installation Precautions:

Hp procurve 2650: install guide.
Hide thumbs

Advertisement

Installation Precautions:

Follow these precautions when installing your HP Switch 2650.
W a r n i n g
C a u t i o n s
The rack or cabinet should be adequately secured to prevent it from
becoming unstable and/or falling over.
Devices installed in a rack or cabinet should be mounted as low as
possible, with the heaviest devices at the bottom and progressively lighter
devices installed above.
For safe operation, do not install the switch with the back face of the
switch (with the fan vents) facing either downward or upward.
Make sure that the power source circuits are properly grounded, then use
the power cord supplied with the switch to connect it to the power source.
If your installation requires a different power cord than the one supplied
with the switch, be sure to use a power cord displaying the mark of the
safety agency that defines the regulations for power cords in your country.
The mark is your assurance that the power cord can be used safely with
the switch.
When installing the switch, note that the AC outlet should be near the
switch and should be easily accessible in case the switch must be powered
off.
Ensure that the switch does not overload the power circuits, wiring, and
over-current protection. To determine the possibility of overloading the
supply circuits, add together the ampere ratings of all devices installed on
the same circuit as the switch and compare the total with the rating limit
for the circuit. The maximum ampere ratings are usually printed on the
devices near the AC power connectors.
Do not install the switch in an environment where the operating ambient
temperature might exceed 55°C (131°F).
Make sure the air flow around the sides and back of the switch is not
restricted.
Installing the Switch 2650
Installation Procedures
2-3

Advertisement

   Related Manuals for HP ProCurve 2650

This manual also for:

J4899b, J4899c, J8165a

Comments to this Manuals

Symbols: 0
Latest comments: