Mount The Switch; Rack Or Cabinet Mounting - HP ProCurve 2650 Install Manual

Installing the Switch 2650
Installation Procedures

4. Mount the Switch

After you have verified that the switch passes self test, you are ready to mount
the switch in a stable location. The Switch 2650 can be mounted in these ways:
■
■
■

Rack or Cabinet Mounting

The Switch 2650 is designed to be mounted in any EIA-standard 19-inch telco
rack or communication equipment cabinet. Note that the mounting brackets
have multiple mounting holes and can be rotated allowing for a wide variety
of mounting options.
W a r n i n g
For safe operation, please read the mounting precautions on
page 2-3, before mounting a switch.
E q u i p m e n t
The 12-24 screws supplied with the switch are the correct threading for
C a b i n e t standard EIA/TIA open 19-inch racks. If you are installing the switch in an
equipment cabinet such as a server cabinet, use the clips and screws that came
N o t e
with the cabinet in place of the 12-24 screws that are supplied with the switch.
Complete step 1, on the next page. Then, plan which four holes you will be
using in the cabinet and install all four clips and partially install the two bottom
screws, as described in step 2 on the following page. Then proceed to step 3.
2-10
in a rack or cabinet
on a horizontal surface
on a wall