HP ProCurve 2650 Install Manual: Led Behavior:

Hp procurve 2650: install guide.
Hide thumbs

Advertisement

2.
Check the LEDs on the switch as described below.
Self Test LED
hp procurve
2
1
switch
1
2650
J4899A
Self
Test
Lnk
Port
LED
Act
View
Power
Fan
FDx
Status
Spd
Fault
Spd mode:
off = 10 Mbps,
Clear
Reset
Power and
Fault LEDs
When the switch is powered on, it performs its diagnostic self test. Self
test takes approximately 50 seconds to complete.

LED Behavior:

During the self test:
Initially, all the switch and port LEDs are on and stay on for most of
the duration of the self test.
Most of the LEDs go off and then may come on again during phases
of the self test. For the duration of the self test, the Self Test LED stays
on.
When the self test completes successfully:
The Power and Fan Status LEDs remain on.
The Fault and Self Test LEDs go off.
The port LEDs on the front of the switch go into their normal opera-
tional mode:
If the ports are connected to active network devices, the LEDs
behave according to the Port LED View selected. In the default
view mode (Link), the LEDs should be on.
If the ports are not connected to active network devices, the LEDs
will stay off.
If the LED display is different than what is described above, especially if
the Fault and Self Test LEDs stay on for more than 60 seconds or they start
blinking, the self test has not completed correctly. Refer to chapter 4,
"Troubleshooting" for diagnostic help.
Switch port LEDs
4
6
8
10
12
3
5
7
9
11
13
flash = 100 Mbps,
on = 1000 Mbps
Installing the Switch 2650
Installation Procedures
16
14
18
20
22
15
17
19
21
23
15
17
16
18
10/100Base-TX P
24
2-9

Advertisement

   Related Manuals for HP ProCurve 2650

This manual also for:

J4899b, J4899c, J8165a

Comments to this Manuals

Symbols: 0
Latest comments: