Front Of The Switch; Network Ports - HP ProCurve 2650 Install Manual

Introducing the HP Procurve Switch 2650

Front of the Switch

Front of the Switch
Power
and Fault
Self Test and Fan
LEDs
Status LEDs
4 6
hp procurve 2 8
1 3 5 7
switch 1
2650
J4899A
Self
Test
Lnk
Port
LED
Act
View
Power
Fan
FDx
Status
Spd
Fault
Spd mode: off = 10 Mbps, flash = 100 Mbps, on = 1000 Mbps
Reset Clear
Port LED View select
Reset and Clear
button and indicator LEDs
buttons

Network Ports

■
■
Dual-Personality Port Operation. By default, the RJ-45 connnectors are
enabled. If a mini-GBIC is installed in a slot, it is enabled and the associated
RJ-45 connector is disabled and cannot be used. If the mini-GBIC is removed,
the associated RJ-45 port is automatically re-enabled.
1-2
Switch port LEDs
16
10 12 14 18 20 22
9 11 13 15 17 19 21 23
15 17
16 18
10/100Base-TX Ports (1 - 48)
10/100Base-TX RJ-45 ports*
* All 10/100Base-TX RJ-45 ports have the HP Auto MDIX feature.
10/100/1000Base-T ports have the IEEE Auto MDI/MDI-X feature.
48 auto-sensing 10/100Base-TX ports.
All these ports have the "HP Auto MDIX" feature, which means that you
can use either straight-through or crossover twisted-pair cables to
connect any network devices to the switch.
Two dual-personality ports. You can use either the 10/100/1000Base-T
RJ-45 connector, or install a supported HP Procurve mini-GBIC for fiber-
optic connections.
The RJ-45 connectors support the IEEE Auto MDI/MDI-X feature, which
operates the same as the "HP Auto-MDIX" feature.
26 34 36
24 28 30 32 38
25 27 29 31 33 35 37
31 33
32 34
HP Procurve Switch 2650
40 42 44
46 48
39 41 43 45 47
47
M M
T 49 T 50
48
!
Use only one (T or M) for each Gigabit port
Dual-personality ports
(1000Base-T* or mini-GBIC)
Gig-T
Ports
Mini-
GBIC
Ports