Rs485 - Honeywell 1602-B User Manual

RS485

Scan one of the following "Plug and Play" codes to program the scanner for an IBM POS terminal interface. This interface
is only appropriate for an Access Point.
Note: After scanning one of these codes, you must power cycle the cash register.
IBM Port 5B Interface
IBM Port 17 Interface
Each bar code above also programs the following suffixes for each symbology:
* Suffixes programmed for Code 128 with IBM 4683 Port 5B, IBM 4683 Port 9B HHBCR-1, and IBM 4683 Port 17 Interfaces
**Suffixes programmed for Code 128 with IBM 4683 Port 9 HHBCR-2 Interface
RS485 Packet Mode
The following selection allows you to break up large bar code data into smaller packets on an IBM POS terminal. To
break up large bar codes into small packets, scan the Packet Mode On bar code below. Scan the Packet Mode Off
bar code if you want large bar code data to be sent to the host in a single chunk. Default = Packet Mode Off.
* Packet Mode Off
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
Symbology Suffix
EAN 8 0C
EAN 13 16
UPC A 0D
UPC E 0A
Symbology Suffix
Code 39 00 0A 0B
Interleaved 2 of 5 00 0D 0B
Code 128 * 00 0A 0B
Code 128 ** 00 18 0B
MaxiCode 00 2F 0B
IBM Port 9B
HHBCR-1 Interface
IBM Port 9B
HHBCR-2 Interface
Packet Mode On
2 - 13