Terminal Id Table; Data Format Editor Commands - Honeywell 1602-B User Manual

Wireless area-imaging pocket scanner

Table of Contents

Data Format Editor Commands

When working with the Data Format Editor, a virtual cursor is moved along your input data string. The following commands are

used to both move this cursor to different positions, and to select, replace, and insert data into the final output.

Send Commands

Send all characters

F1 Include in the output message all of the characters from the input message, starting from current cursor position,

followed by an insert character. Syntax = F1xx where xx stands for the insert character's hex value for its ASCII code.

Refer to the

Send a number of characters

F2 Include in the output message a number of characters followed by an insert character. Start from the current cursor

position and continue for "nn" characters or through the last character in the input message, followed by character "xx."

Syntax = F2nnxx where nn stands for the numeric value (00-99) for the number of characters, and xx stands for the

insert character's hex value for its ASCII code. Refer to the

page A-3 for decimal, hex and character codes.

F2 Example: Send a number of characters

Send the first 10 characters from the bar code above, followed by a carriage return. Command string: F2100D

F2 is the "Send a number of characters" command

10 is the number of characters to send

0D is the hex value for a CR

The data is output as: 1234567890

F2 and F1 Example: Split characters into 2 lines

Send the first 10 characters from the bar code above, followed by a carriage return, followed by the rest of the charac-

ters.

Command string: F2100DF10D

F2 is the "Send a number of characters" command

10 is the number of characters to send for the first line

0D is the hex value for a CR

The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.