Interfunction Delay; Intermessage Delay - Honeywell 1602-B User Manual

Next, scan the Character to Trigger Delay bar code, tthen the 2-digit hex value for a printable character to trigger the
delay (see Lower ASCII Reference Table
Delay Length
To remove this delay, scan the Delay Length bar code, and set the number of delays to 0. Scan the Save bar code using
the Programming Chart

Interfunction Delay

An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be placed between the transmission of each
control character in the message string. Scan the Interfunction Delay bar code below, then scan the number of 5ms
delays, and the Save bar code using the
To remove this delay, scan the Interfunction Delay bar code, then set the number of delays to 0. Scan the Save bar code
using the Programming Chart

Intermessage Delay

An intermessage delay of up to 5000 milliseconds (in 5ms increments) may be placed between each scan transmission.
Scan the Intermessage Delay bar code below, then scan the number of 5ms delays, and the Save bar code using the
Programming Chart
To remove this delay, scan the Intermessage Delay bar code, then set the number of delays to 0. Scan the Save bar code
using the Programming Chart
5 - 4
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
on page A-4).
inside the back cover of this manual.
Programming Chart
Prefix
STX 1
inside the back cover of this manual.
inside the back cover of this manual.
1st Scan Transmission
inside the back cover of this manual.
inside the back cover of this manual.
Scanned Data Suffix
HT 2 3 4 5 CR LF
Interfunction Delays
Interfunction Delay
2nd Scan Transmission
Intermessage Delay
Intermessage Delay
Character to Trigger Delay