Resetting The Factory Defaults: All Application Work Groups; Resetting The Custom Defaults: All Application Work Groups; Access Point Operations; Linking The Scanner To An Access Point - Honeywell 1602-B User Manual

Resetting the Factory Defaults: All Application Work Groups

The following bar code defaults all of the work groups to the factory default settings.
To see what the factory default settings are, refer to the table of
uct default settings for each of the commands are indicated by an asterisk (*).
Note: Scanning this bar code also causes both the scanner and the host to perform a reset and become unlinked. You must
relink (pair) the scanner to the host. Refer to
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping while all scanners are relinked to
the host and the settings are changed.

Resetting the Custom Defaults: All Application Work Groups

If you want the custom default settings restored to all of the work groups, scan the Custom Product Default Settings bar code
below. (If there are no custom defaults, it will reset the work groups to the factory defaults.) See
page 1-6 for further information about custom defaults.
Note: Scanning this bar code also causes both the scanner and the host to perform a reset and become unlinked. You must
relink (pair) the scanner to the host. See
If your scanner is in multiple scanner mode, you will hear up to 30 seconds of beeping while all scanners are relinked to
the host and the settings are changed.

Access Point Operations

The Voyager 1602g can pair with a Honeywell Access Point (AP01-010BT or AP01-100BT), which provides 2-way communica-
tion between the scanner and host.

Linking the Scanner to an Access Point

Turn on the host computer (laptop/desktop). Plug the interface cable into the Access Point
first and then into the appropriate port on the computer. The Page button lights up when the
connection to the host is made.
The HEC and TEC codes identified in this watermark supersede any conflicting HEC or TEC codes displayed in the drawing.
PAPDFT&
Factory Default Settings:
All Work Groups
Menu Commands,
Bluetooth Settings, page 3-1 for additional information.
Custom Default Settings:
All Work Groups
Bluetooth Settings, page 3-1 for additional information.
beginning on page 9-4. The standard prod-
Setting Custom Defaults on
Page
Button
3 - 13