HP Designjet 700 User Manual page 50

Setting Up the Plotter
Task 8: (Serial Interface Users Only) Configure the Interface
To Change the Plotter's Serial Interface Settings
Through the front-panel display, you can create and save two sets of configurations
for the serial interface, called Configurations A and B. By default they are set to
the factory defaults shown in the table on page 1-29. The factory default
configuration is always available as well, giving you up to three stored
configurations to choose from.
The instructions that follow explain how to specify and apply Configuration A.
Configuration B can be specified in the same way. To restore the factory default
configuration see page 7-6
1-30