If the Output Contains Only a Partial Plot
Did you press
Form Feed and Cut
plotter? If so, you have ended the data transmission and will have to print the
plot again. (You normally don't need to press
the plot.)
The
I/O Setup / I/O Timeout
plot again. See page 7-9.
The file may be too big for the plotter's memory. For information on memory
expansion modules, see page 11-14.
There may be a communications problem between your computer and the
plotter. Make sure interface cable is connected properly.
Check to make sure that your software settings are correct for your current plot
size (e.g., long-axis plots).
If you are using network software, make sure it has not timed out.
See also under "If the plot is clipped" on page 9-12.
Solving Problems with Plot Position or Content
before all the data was received by the
Form Feed and Cut
setting may be too short. Increase the setting and
Troubleshooting
to unload
9-11