HP Designjet 700 User Manual page 192

Front-Panel Messages
Front-Panel Messages
This is a list of all possible messages in the front-panel display. If you need to do
something, it is shown in italics in the
The messages are listed in alphabetical order.
Message Explanation and Action
Alignment error The alignment procedure has failed. Check that an opaque media is loaded.
Press
Continue
reseating any of the print cartridges. Do not lift the window while cartridge
alignment is being performed .
Calibrate error The calibration plot was loaded incorrectly and it could not be measured. Press
to continue, then reload the plot for measurement. Follow front panel instructions.
Continue
Calibration done Accuracy calibration is complete. Press
Continue
Close roll cover Rewind the media to take up any slack in the roll, close the roll cover, then press
Continue
Press
Create pattern
Press
Measure pattern
Edge not found The plotter could not find edge of media during loading procedure. Check the
Reload media leading edge of the media for unevenness or tears; cut a straight edge, if
necessary, and reload. Be sure to position the right edge along the perforated line
on the entry platen when loading.
Lift lever Lift the lever at the right of the plotter.
Load arrow edge Remove calibration plot, turn it so that the edge with arrows printed on it is print
print side down side down, then load that edge into the plotter.
Load cancelled You pressed the
Remove media media.
Load error You inserted media with the media lever raised. Lower the lever and reload the
media.
Remove media
Load media Load media to proceed with cartridge alignment.
to align cartridges
When you have finished aligning the roll media as instructed, lower the lever at
Lower lever
after aligning the right of the plotter.
10-2
to continue and force the automatic alignment procedure again by
to continue.
to create the pattern for automatic calibration.
to start the automatic calibration.
button while media loading was in progress. Remove
Cancel
Explanation and Action
to continue.
column.