Troubleshooting
Solving Problems with Plot Position or Content
If the Plot Is Distorted or Unintelligible
If One Plot Overlays Another Plot on the Same Sheet
If Pen Settings Seem To Have No Effect
!
See page 5-6.
If the Plotter Produces a Black and White Plot When You
Expected a Color Plot
750C Plus
9-14
The interface cable between your computer and the plotter could be faulty. Try
another cable to see if the problem is corrected.
If you are using a serial interface between the plotter and your computer, make
sure the plotter's serial interface settings match the settings and requirements of
your software and hardware. See page 1-29.
The
I/O Setup / I/O Timeout
plot again. See page 7-9.
If
Device setup / Lang
is set to
setting and send the files again.
Terminator
Either you have changed them in
select that palette in
Pen settings / Palette,
or you expected the software-driven pen settings but the front panel
is not set to
settings / Palette
Check the front panel
Color/Mono
software.
setting may be too long. Decrease the setting and
7586,HP–GL/2 (the default)
Pen settings / Define palette
Software.
setting, and the equivalent setting in your
, try changing the
but forgotten to
Pen