Kohler KD62V12 Service And Repair Manual page 264

Appendix
Standard tightening torques
5.3 Standard tightening torques
5.3.1 Lubricant and threadlocker application rules
Application method
Tab. 61: Lubricant and threadlocker application rules
5.3.2 Screws pre-tightening, reuse and marking
NOTICE
Property damage by improper pre-tightening, turning angle or reuse of screws or nuts.
Improper pre-tightening, turning angle or reuse of screws or nuts could lead to the rupture of the
screw or nut and lead to property damage by malfunction, ejection, fall or tilting of components.
u Respect following pre-tightening, turning angle, reuse and marking specifications.
u In case of failure or damage, replace any threaded fastener immediately by the authorized
personnel.
Information
The values of the pre-tightening torque and the turning angle are specified in the maintenance
tasks.
Unless otherwise noted, use the standard torque values into the column of screws quality class
"8.8" to tighten screws and bolts.
The screws quality classes "10.9" and "12.9" are always indicated with the "Nm" symbol.
264
Apply lubricant under the screw
head and on the first third of the
thread.
Apply threadlocker on the first
third of the thread.
© 2021 by Kohler Co. All rights reserved.
Service and Repair Manual
Product
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
O = Engine oil
XX = Loctite 243
YY = Loctite 577
KD62V12 33525088601_7_1 EN_US
2021-07